路由器(Router)是連接兩個或多個網絡的硬件設備,在網絡間起網關的作用,是讀取每一個數據包中的地址然后決定如何傳送的專用智能性的網絡設備,路由器最主要的功能為實現信息的轉送。 HP刀片6120交換機配置端口聚合
HP 6120配置
interfaces ethernet 1-4
lacp active
Cisco 2960配置
interface rang GigabitEthernet0/1-4
channel-group 13 mode active
no shutdown
!
interface Port-channel13
switchport access vlan 230
switchport mode access
在HP 6120里驗證結果
ProCurve 6120G/XG Blade Switch# show lacp
PORT LACP TRUNK PORT LACP LACP
NUMB ENABLED GROUP STATUS PARTNER STATUS
—- ——- ——- ——- ——- ——-
1 Active Dyn1 Up Yes Success
2 Active Dyn1 Up Yes Success
3 Active Dyn1 Up Yes Success
4 Active Dyn1 Up Yes Success
在Cisco 2960里驗證結果
SW# show etherchannel summary
Group Port-channel Protocol Ports
——+————-+———–+———————————————–
13 Po13(SU) LACP Gi0/0(P) Gi0/1(P) Gi0/2(P)
Gi0/3(P)
兩端對應的4個端口都已經up,lacp的狀態也是正常,說明配置成功了。
本文可以幫助您基本地設置和管理您的路由器。
|